Displaying Vccs - Cisco Catalyst 8540 MSR Configuration Manual

Configuring Virtual Channel Connections
The following example shows how to configure the internal cross-connect PVC on Switch C between
interface ATM 0/0/0, VPI = 2, VCI = 100, and interface ATM 0/0/1, VPI 50, VCI = 255:
Switch-C(config)# interface atm 0/0/0
Switch-C(config-if)# atm pvc 2 100 interface atm 0/0/1 50 255
Each subsequent VC cross-connection and link must be configured until the VC is terminated to create
the entire VCC.
Note The above examples show how to configure cross-connections using one command. This is the preferred
method, but it is also possible to configure each leg separately, then connect them with the atm pvc vpi
vci interface atm card/subcard/port vpi vci command. This alternative method requires more steps, but
might be convenient if each leg has many additional configuration parameters or if you have configured
individual legs with SNMP commands and you want to connect them with one CLI command.

Displaying VCCs

To show the VCC configuration, use the following EXEC commands:
Command
show atm interface [atm card/subcard/port]
show atm vc [interface atm card/subcard/port
vpi vci]
The following examples differ depending on the feature card installed on the processor.
Note
ATM Switch Router Software Configuration Guide
7-4
Chapter 7
Purpose
Shows the ATM interface configuration.
Shows the PVC interface configuration.
Configuring Virtual Connections
OL-7396-01