Configuring Point-To-Multipoint Structured Ces Soft Pvcs; Configuring The Destination Side Of A Point-To-Multipoint Structured Ces Soft Pvc - Cisco Catalyst 8540 MSR Configuration Manual

Chapter 19 Configuring Circuit Emulation Services

Configuring Point-to-Multipoint Structured CES Soft PVCs

Figure 19-11
Figure 19-11 Point-to-Multipoint Structured CES Soft PVC Connection Example
CBR 4/0/0
CES PVC 1 P2MP
This section describes configuring structured point-to-multipoint CES soft PVC connections and
includes the following topics:
•
•

Configuring the Destination Side of a Point-to-Multipoint Structured CES Soft PVC

To configure the destination side of a point-to-multipoint structured CES soft PVC connection, perform
the following steps, beginning in privileged EXEC mode:
Command
Step 1 Dest_One# show ces status
Step 2 Dest_One# configure terminal
Dest_One(config)#
Step 3 Dest_One(config)# interface cbr
card/subcard/port
Dest_One(config-if)#
Step 4 Dest_One(config-if)# shutdown
OL-7396-01
gives an example of point-to-multipoint structured CES soft PVC connections.
Address = 47.0091.8100.0000.0003.6bb4.c501.4000.0c80.9030.10
CES Source
ATM network
Address = 47.0091.8100.0000.0003.6bb4.c502.4000.0c80.9030.10
Configuring the Destination Side of a Point-to-Multipoint Structured CES Soft PVC
Configuring the Source Side of a Point-to-Multipoint Structured CES Soft PVC
Configuring Point-to-Multipoint CES Soft PVC Connections
VPI = 0, VCI = 16
CBR 1/1/0 CES PVC 1
Leaf =30
Dest_One
Dest_Two
Leaf = 101
CBR 1/1/2 CES PVC 1
VPI= 0, VCI = 2064
Purpose
Displays information about current CBR
interfaces.
Use this command to choose the destination port.
Enters configuration mode from the terminal.
Selects the physical interface to configure.
Disables the interface.
ATM Switch Router Software Configuration Guide
19-69