Displaying The Interface Maximum Individual Traffic Parameter Configuration - Cisco Catalyst 8540 MSR Configuration Manual

Atm switch router software configuration guide
Hide thumbs Also See for Catalyst 8540 MSR:
Table of Contents

Advertisement

Configuring Physical and Logical Interface Parameters
Switch(config)# interface atm 3/0/0
Switch(config-if)# atm cac max-cdvt cbr receive 75000

Displaying the Interface Maximum Individual Traffic Parameter Configuration

To display the interface maximum individual traffic parameter configuration, use the following EXEC
command:
Command
show atm interface resource atm
[card/subcard/port[.vpt#]]
Example
The following example shows the interface maximum individual traffic configuration with switch
processor feature card installed:
Switch> show atm interface resource atm 3/0/0
Resource Management configuration:
<information deleted>
ATM Switch Router Software Configuration Guide
9-30
Service Classes:
Service Category map: c1 cbr, c2 vbr-rt, c3 vbr-nrt, c4 abr, c5 ubr
Scheduling: RS c1 WRR c2, WRR c3, WRR c4, WRR c5
WRR Weight: 8 c2, 1 c3, 1 c4, 1 c5
Pacing: disabled
0 Kbps rate configured, 0 Kbps rate installed
Service Categories supported: cbr,vbr-rt,vbr-nrt,abr,ubr
Link Distance: 0 kilometers
Controlled Link sharing:
Max aggregate guaranteed services: none RX,
Max bandwidth: none cbr RX, none cbr TX, none vbr RX, none vbr TX,
none abr RX, none abr TX, none ubr RX, none ubr TX
Min bandwidth: none cbr RX, none cbr TX, none vbr RX, none vbr TX,
none abr RX, none abr TX, none ubr RX, none ubr TX
Best effort connection limit: enabled
Max traffic parameters by service (rate in Kbps, tolerance in cell-times):
Peak-cell-rate RX: none cbr, none vbr, none abr, none ubr
Peak-cell-rate TX: none cbr, none vbr, none abr, none ubr
Sustained-cell-rate: none vbr RX, none vbr TX
Minimum-cell-rate RX: none abr, none ubr
Minimum-cell-rate TX: none abr, none ubr
CDVT RX: none cbr, none vbr, none abr, none ubr
CDVT TX: none cbr, none vbr, none abr, none ubr
MBS: none vbr RX, none vbr TX
Chapter 9
Configuring Resource Management
Purpose
Displays the controlled link sharing
configuration.
none TX
2000 max connections
OL-7396-01

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst 8510 msrLightstream 1010

Table of Contents