Cisco Catalyst 8540 MSR Configuration Manual page 173

Atm switch router software configuration guide
Hide thumbs Also See for Catalyst 8540 MSR:
Table of Contents

Advertisement

Chapter 7
Configuring Virtual Connections
The following example modifies the packet discard option to On for an existing soft PVC.
Switch(config)# intertace atm 0/0/3
Switch(config-if)# atm soft-vc 8 990 pd on
The following example displays the packet-discard-option as enabled for the soft PVC
configured on ATM interface 0/0/3.
Switch# show atm vc interface atm 0/0/3 8 990
Interface: ATM0/0/3, Type: oc3suni
VPI = 8
Status: UP
Time-since-last-status-change: 00:00:22
Connection-type: SoftVC
Cast-type: point-to-point
Hold-priority: none
Soft vc location: Source
Remote ATM address: 47.0091.8100.0011.0050.e202.9f01.4000.0c80.1000.00
Remote VPI: 8
Remote VCI: 990
Soft vc call state: Active
Number of soft vc re-try attempts: 0
First-retry-interval: 5000 milliseconds
Maximum-retry-interval: 60000 milliseconds
Aggregate admin weight: 5040
TIME STAMPS:
Current Slot:0
Outgoing Setup
Incoming Connect
Outgoing Release
Incoming Rel comp
Packet-discard-option: enabled
Usage-Parameter-Control (UPC): pass
Wrr weight: Not-applicable
Number of OAM-configured connections: 60
OAM-configuration: disabled
OAM-states:
Cross-connect-interface: ATM0/1/0, Type: oc12suni
Cross-connect-VPI = 0
Cross-connect-VCI = 37
Cross-connect-UPC: pass
Cross-connect OAM-configuration: disabled
Cross-connect OAM-state:
Threshold Group: 1, Cells queued: 0
Rx cells: 0, Tx cells: 0
Tx Clp0:0,
Rx Clp0:0,
Rx Upc Violations:0, Rx cell drops:0
Rx pkts:0, Rx pkt drops:0
Rx connection-traffic-table-index: 444
Rx service-category: CBR (Constant Bit Rate)
Rx pcr-clp01: 256
Rx scr-clp01: none
Rx mcr-clp01: none
Rx
Rx
Tx connection-traffic-table-index: 444
Tx service-category: CBR (Constant Bit Rate)
Tx pcr-clp01: 256
Tx scr-clp01: none
Tx mcr-clp01: none
Tx
Tx
OL-7396-01
VCI = 990
December 11 02:05:43.535
December 11 02:05:43.555
December 11 02:07:34.891
December 11 02:07:34.891
Not-applicable
Not-applicable
Tx Clp1: 0
Rx Clp1: 0
cdvt: 1024 (from default for interface)
mbs: none
cdvt: none
mbs: none
Configuring Soft PVC Connections
ATM Switch Router Software Configuration Guide
7-25

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst 8510 msrLightstream 1010

Table of Contents