Configuring Bridging - Cisco Catalyst 8540 MSR Configuration Manual

Atm switch router software configuration guide
Hide thumbs Also See for Catalyst 8540 MSR:
Table of Contents

Advertisement

Chapter 25
Configuring ATM Router Module Interfaces

Configuring Bridging

All PVCs configured on ATM router module interfaces are used for bridging.
To configure bridging on an ATM router module interface, use the following commands, beginning in
global configuration mode:
Command
Step 1
Switch(config)# interface atm card/subcard/port
Switch(config-if)#
Step 2
Switch(config-if)# atm pvc 2 vci interface atm
card/subcard/port vpi
Step 3
Switch(config-if)# bridge-group number
Step 4
Switch(config-if)# end
Switch(config)#
Step 5
Switch(config)# interface fastethernet
card/subcard/port
Switch(config-if)#
Step 6
Switch(config-if)# no cdp enable
Step 7
Switch(config-if)# bridge-group number
Step 8
Switch(config-if)# end
Switch(config)#
Step 9
Switch(config)# bridge number protocol ieee
Example
The following example shows how to configure bridging on a Catalyst 8540 MSR with a Fast Ethernet
interface module in slot 0, an ATM interface module in slot 1, and an ATM router module in slot 3.
Figure 25-9
Figure 25-9 Example Network for Bridging
MAC addr = 0000.0CAC.BE94
Switch(config)# interface atm 3/0/0
Switch(config-if)# atm pvc 2 200 interface atm 1/0/0 0 200
Switch(config-if)# bridge-group 5
Switch(config-if)# end
OL-7396-01
shows an example bridging network.
Cisco 7500 router A
IF = atm 1/0/0
10.10.10.2
IF = atm 0
Purpose
Specifies the interface on the ATM router module
to configure.
Configures a PVC.
Note
The VPI number on the ATM router
module interface must be 2.
Assigns the interface to a bridge group.
Returns to global configuration mode.
Specifies the Fast Ethernet interface to configure.
Disables Cisco Discovery Protocol on the
interface.
Assigns the interface to a bridge group.
Returns to global configuration mode.
Specifies the IEEE 802.1D Spanning-Tree
Protocol for the bridge group.
ATM switch
router
Cisco 7500 router B
IF = fa 0/0/0
MAC addr = 0060.3E59.C63C
ATM Switch Router Software Configuration Guide
Configuring Bridging
10.10.10.1
IF = e0
25-25

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst 8510 msrLightstream 1010

Table of Contents