Default Configuration; Relationships With Other Features; Common Smartport Tasks - Cisco SX350 Series Administration Manual

Managed switches

Hide thumbs Also See for SX350 Series:

Table of Contents

Default Configuration

Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x

Smartport is always available. By default, Auto Smartport is enabled by Auto Voice VLAN,

relies on both CDP and LLDP to detect attaching device's Smartport type, and detects

Smartport type IP phone, IP phone + Desktop, Switch, and Wireless Access Point.

for a description of the voice factory defaults.

Auto Smartport is enabled by default and may be disabled. Telephony OUI cannot function

concurrently with Auto Smartport, and Auto Voice VLAN. Auto Smartport must be disabled

before enabling Telephony OUI.

This section describes some common tasks to setup Smartport and Auto Smartport.

Workflow1: To globally enable Auto Smartport on the device, and to configure a port

with Auto Smartport, perform the following steps:

To enable the Auto Smartport feature on the device, open the

Administrative Auto Smartport to Enable or Enable by Voice VLAN.

Select whether the device is to process CDP and/or LLDP advertisements from connected

Select which type of devices are to be detected in the Auto Smartport Device Detection field.

To enable the Auto Smartport feature on one or more interfaces, open the

Select the interface, and click Edit.

Select Auto Smartport in the Smartport Application field.

Check or uncheck Persistent Status if desired.

Click Apply.

Interface Settings

Show Quick Links

Table of Contents