Default Rip Configuration; Configuring Basic Rip Parameters - Cisco Catalyst 3750-X Software Configuration Manual

Chapter 42 Configuring IP Unicast Routing

Default RIP Configuration

Table 42-4 Default RIP Configuration
Feature
Auto summary
Default-information originate
Default metric
IP RIP authentication key-chain No authentication.
IP RIP receive version
IP RIP send version
IP RIP triggered
IP split horizon
Neighbor
Network
Offset list
Output delay
Timers basic
Validate-update-source
Version

Configuring Basic RIP Parameters

To configure RIP, you enable RIP routing for a network and optionally configure other parameters. On
Note
the Catalyst 3750-X and 3560-X switches, RIP configuration commands are ignored until you configure
the network number.
Beginning in privileged EXEC mode, follow these steps to enable and configure RIP:
Command
Step 1
configure terminal
Step 2
ip routing
Step 3 router rip
OL-21521-01
Default Setting
Enabled.
Disabled.
Built-in; automatic metric translations.
Authentication mode: clear text.
According to the version router configuration command.
According to the version router configuration command.
According to the version router configuration command.
Varies with media.
None defined.
None specified.
Disabled.
0 milliseconds.
Update: 30 seconds.
•
Invalid: 180 seconds.
•
Hold-down: 180 seconds.
•
Flush: 240 seconds.
•
Enabled.
Receives RIP Version 1 and 2 packets; sends Version 1 packets.
Purpose
Enter global configuration mode.
Enable IP routing. (Required only if IP routing is disabled.)
Enable a RIP routing process, and enter router configuration mode.
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
Configuring RIP
42-21