Default Rip Configuration; Configuring Basic Rip Parameters - Cisco 3845 - Security Bundle Router Software Manual

Configuring RIP
If the router has a default network path, RIP advertises a route that links the router to the pseudonetwork
0.0.0.0. The 0.0.0.0 network does not exist, but is treated by RIP as a network to implement default
routing. The switch advertises the default network if a default was learned by RIP or if the router has a
gateway of last resort and RIP is configured with a default metric. RIP sends updates to the interfaces in
specified networks. If an interface's network is not specified, it is not advertised in any RIP update.
These sections contain this configuration information:
•
•
•
•

Default RIP Configuration

Table 29-4 Default RIP Configuration
Feature
Auto summary
Default-information originate
Default metric
IP RIP authentication key-chain
IP RIP receive version
IP RIP send version
IP RIP triggered
IP split horizon
Neighbor
Network
Offset list
Output delay
Timers basic
Validate-update-source
Version

Configuring Basic RIP Parameters

To configure RIP, you enable RIP routing for a network and optionally configure other parameters. On
the Cisco ME switch, RIP configuration commands are ignored until you configure the network number.
Cisco ME 3800X and 3600X Switch Software Configuration Guide
29-18
Default RIP Configuration, page 29-18
Configuring Basic RIP Parameters, page 29-18
Configuring RIP Authentication, page 29-20
Configuring Split Horizon, page 29-20
Default Setting
Enabled.
Disabled.
Built-in; automatic metric translations.
No authentication.
Authentication mode: clear text.
According to the version router configuration command.
According to the version router configuration command.
According to the version router configuration command.
Varies with media.
None defined.
None specified.
Disabled.
0 milliseconds.
• Update: 30 seconds.
Invalid: 180 seconds.
•
Hold-down: 180 seconds.
•
Flush: 240 seconds.
•
Enabled.
Receives RIP Version 1 and 2 packets; sends Version 1 packets.
Chapter 29 Configuring IP Unicast Routing
OL-23400-01