Table of Contents
Advertisement
NOTE: Empty classifier groups have no effect on the router's classification of packets
and are ignored by the router. You might inadvertently create empty classifier groups
in a policy if you use both the newer CLI style and the older CLI style, which used
the Policy List Configuration mode version of the classifier list commands.
Related Topics
Applying Policy Lists to Interfaces and Profiles Overview
You can assign a policy list to supported interfaces and profiles. Policy lists are
supported on Frame Relay, IP, IPv6, GRE tunnel, MPLS layer 2, and VLAN interfaces.
You can also specify IP, IPv6, and L2TP policies in profiles to assign a policy list to
an interface. In either case, you can enable or disable the recording of statistics for
bytes and packets affected by the assigned policy.
You can also preserve statistics when you attach a new policy that has a classifier
list that is the same for both the original and the new policy attachments.
You can use policy commands to assign an ATM, Frame Relay, GRE tunnel, IP, IPv6,
MPLS, or VLAN policy list to an interface. Also, you can use them to specify an IP,
IPv6, or L2TP policy list to a profile, which then assigns the policy to the interfaces
to which the profile is attached
Classifier Groups and Policy Rules Overview on page 31
Creating Rate-Limit Profiles on page 77
Monitoring Policy Management Overview on page 181
aggregation-node
classifier-group
ip policy-parameter hierarchical
ip policy-parameter reference-rate
ipv6 policy-parameter hierarchical
ipv6 policy-parameter reference-rate
l2tp policy-parameter hierarchical
l2tp policy-parameter reference-rate
mpls policy-parameter hierarchical
mpls policy-parameter reference-rate
next-parent
parent-group
policy-parameter hierarchical
Applying Policy Lists to Interfaces and Profiles Overview
Chapter 4: Creating Classifier Groups and Policy Rules
43
Advertisement
Table of Contents
