Table of Contents
Advertisement
JUNOSe 11.1.x Policy Management Configuration Guide
Figure 1: Constructing an IP Policy List
You can create a policy list with an unlimited number of classifier groups, each
containing an unlimited number of rules. These rules can reference up to 512 classifier
entries.
If you enter a policy-list command and then enter exit, the router creates a policy
list with no rules. If the router does not find any rules in a policy, it inserts a default
filter rule. Attaching this policy list to an interface filters all packets on that interface.
NOTE: If you do not specify one of the frame-relay, gre-tunnel, ip, ipv6, l2tp, mpls,
or vlan keywords, the router creates an IP policy list. This version of the command
has been deprecated and may be removed in a future release.
You can create policy lists for ATM, Frame Relay, IP, IPv6, GRE tunnels, L2TP, MPLS,
and VLANs.
NOTE: Commands that you issue in Policy Configuration mode do not take effect
until you exit from that mode.
Related Topics
18
Policy Lists Overview
Policy Lists Overview on page 17
Monitoring Policy Management Overview on page 181
Advertisement
Table of Contents
