Example #2: Enable Routing For Ports; Example #3. Enable Rip For The Switch - NETGEAR ProSafe FSM7328S Administration Manual

Example #2: Enable Routing for Ports

The following command sequence enables routing and assigns IP addresses for ports 1/2/2 and 1/
2/3.
(Netgear Switch) #config
(Netgear Switch) (Config)#interface 1/2/2
(Netgear Switch) (Interface 1/2/2)#routing
(Netgear Switch) (Interface 1/2/2)#ip address 192.150.2.1 255.255.255.0
(Netgear Switch) (Interface 1/2/2)#exit
(Netgear Switch) (Config)#interface 1/2/3
(Netgear Switch) (Interface 1/2/3)#routing
(Netgear Switch) (Interface 1/2/3)#ip address 192.150.3.1 255.255.255.0
(Netgear Switch) (Interface 1/2/3)#exit
(Netgear Switch) (Config)#exit

Example #3. Enable RIP for the Switch

The next sequence enables RIP for the switch. the route preference defaults to 15.
(Netgear Switch) #config
(Netgear Switch) (Config)#router rip
(Netgear Switch) (Config router)#enable
(Netgear Switch) (Config router)#exit
(Netgear Switch) (Config)#exit
IP Routing Services
NETGEAR 7000 Series Managed Switch Administration Guide
v1.0, March 2006
5-17