Configure The Cos Queue Settings For An Interface - NETGEAR GS418TPP User Manual

8-Port or 16-Port Gigabit Smart Managed Pro Switch Model GS418TPP, GS510TLP, and GS510TPP
10. Click the Apply button.
Your settings are saved.

Configure the CoS queue settings for an interface

You can define what a particular queue does by configuring switch egress queues. You can
control how much bandwidth is used by the queue, the queue depth during times of
congestion, and the scheduling of packet transmission from all queues on a port. Each port
contains its own CoS queue-related configuration.
For information about configuring CoS queue settings globally, see Configure the global
CoS settings on page 258.
To configure CoS queue settings for an interface:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the default IP address of
the switch on page 13.
The login window opens.
4. Enter the switch's password in the Password field.
The default password is password.
The System Information page displays.
5. Select QoS > CoS > Advanced > Interface Queue Configuration.
6. Select whether to display physical interfaces, LAGs, or both by clicking one of the following
links above the table heading:
• 1 (the unit ID of the switch). Only physical interfaces are displayed. This is the default
setting.
• LAG. Only LAGs are displayed.
• All. Both physical interfaces and LAGs are displayed.
Configure Quality of Service 261 User Manual