Line Commands - SMC Networks SMC8748ML3 Management Manual

C L
OMMAND INE
DC (DHCP Server Configuration)
RC (Router Configuration)
CM (Class Map Configuration)
PM (Policy Map Configuration)

Line Commands

You can access the onboard configuration program by attaching a VT100
compatible device to the server's serial port. These commands are used to set
communication parameters for the serial port or Telnet (i.e., a virtual
terminal).
Command
line
login
password
timeout login
response
exec-timeout
password-thresh Sets the password intrusion threshold, which limits
silent-time
databits
*
parity *
speed
*
stopbits
*
4-14
I
NTERFACE
Table 4-5 Line Commands
Function
Identifies a specific line for configuration and
starts the line configuration mode
Enables password checking at login
Specifies a password on a line
Sets the interval that the system waits for a login
attempt
Sets the interval that the command interpreter
waits until user input is detected
the number of failed logon attempts
Sets the amount of time the management console
*
is inaccessible after the number of unsuccessful
logon attempts exceeds the threshold set by the
password-thresh command
Sets the number of data bits per character that are
interpreted and generated by hardware
Defines the generation of a parity bit
Sets the terminal baud rate
Sets the number of the stop bits transmitted per
byte
Mode Page
GC 4-15
LC 4-16
LC 4-17
LC 4-18
LC 4-19
LC 4-20
LC 4-21
LC 4-21
LC 4-22
LC 4-23
LC 4-24