Line Commands; Table 4-5 Line Command Syntax - SMC Networks 6152L2 - annexe 1 Management Manual

C L
OMMAND INE

Line Commands

You can access the onboard configuration program by attaching a VT100
compatible device to the server's serial port. These commands are used to
set communication parameters for the serial port or Telnet (i.e., a virtual
terminal).
Command
line
login
password
timeout login
response
exec-timeout
password-thresh Sets the password intrusion threshold, which
silent-time
*
databits
*
parity
*
speed
stopbits *
disconnect
show line
* These commands only apply to the serial port.
4-14
I
NTERFACE

Table 4-5 Line Command Syntax

Function
Identifies a specific line for configuration and
starts the line configuration mode
Enables password checking at login
Specifies a password on a line
Sets the interval that the system waits for a
login attempt
Sets the interval that the command interpreter
waits until user input is detected
limits the number of failed logon attempts
Sets the amount of time the management
*
console is inaccessible after the number of
unsuccessful logon attempts exceeds the
threshold set by the password-thresh
command
Sets the number of data bits per character that
are interpreted and generated by hardware
Defines the generation of a parity bit
Sets the terminal baud rate
Sets the number of the stop bits transmitted per
byte
Terminates a line connection
Displays a terminal line's parameters
Mode Page
GC 4-15
LC 4-16
LC 4-17
LC 4-18
LC 4-19
LC 4-20
LC 4-21
LC 4-21
LC 4-22
LC 4-23
LC 4-24
PE 4-24
NE, 4-25
PE