Lacp System-Priority - SMC Networks SMC8748ML3 Management Manual

C L
OMMAND INE
Current status:
Created by:
Link status:
Operation speed-duplex: 1000full
Flow control type:
Member Ports:
Console#

lacp system-priority

This command configures a port's LACP system priority. Use the no form to
restore the default setting.
Syntax
lacp {actor | partner} system-priority priority
no lacp {actor | partner} system-priority
• actor - The local side an aggregate link.
• partner - The remote side of an aggregate link.
• priority - This priority is used to determine link aggregation group
(LAG) membership, and to identify this device to other switches
during LAG negotiations. (Range: 0-65535)
Default Setting
32768
Command Mode
Interface Configuration (Ethernet)
Command Usage
• Port must be configured with the same system priority to join the same
LAG.
• System priority is combined with the switch's MAC address to form the
LAG identifier. This identifier is used to indicate a specific LAG during
LACP negotiations with other systems.
• Once the remote side of a link has been established, LACP operational
settings are already in use on that side. Configuring LACP settings for the
partner only applies to its administrative state, not its operational state,
and will only take effect the next time an aggregate link is established
with the partner.
4-208
I
NTERFACE
Lacp
Up
None
Eth1/10, Eth1/11, Eth1/12,