Editing Vlan Groups; Vlan Database; Table 4-59 Vlan Commands; Table 4-60 Editing Vlan Groups - SMC Networks SMC8748ML3 Management Manual

C L
OMMAND INE
Command Groups
Configuring Private
VLANs
Configuring Protocol
VLANs

Editing VLAN Groups

Command

vlan database

vlan
vlan database
This command enters VLAN database mode. All commands in this mode
will take effect immediately.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• Use the VLAN database command mode to add, change, and delete
VLANs. After finishing configuration changes, you can display the
VLAN settings by entering the show vlan command.
• Use the interface vlan command mode to define the port membership
mode and add or remove ports from a VLAN. The results of these
commands are written to the running-configuration file, and you can
display this file by entering the show running-config command.
4-246
I
NTERFACE
Table 4-59 VLAN Commands (Continued)
Function
Configures private VLANs, including uplink and
downlink ports
Configures protocol-based VLANs based on frame
type and protocol

Table 4-60 Editing VLAN Groups

Function
Enters VLAN database mode to add, change,
and delete VLANs
Configures a VLAN, including VID, name and
state
Page
4-257
4-259
Mode Page
GC 4-246
VC 4-247