Ip Ospf Dead-Interval - SMC Networks SMC8748ML3 Management Manual

Gigabit ethernet switch
Hide thumbs Also See for SMC8748ML3:
Table of Contents

Advertisement

C
L
OMMAND
INE

ip ospf dead-interval

This command sets the interval at which hello packets are not seen before
neighbors declare the router down. Use the no form to restore the default
value.
Syntax
ip ospf dead-interval seconds
no ip ospf dead-interval
seconds - The maximum time that neighbor routers can wait for a hello
packet before declaring the transmitting router down. This interval
must be set to the same value for all routers on the network. (Range:
1-65535)
Command Mode
Interface Configuration (VLAN)
Default Setting
40, or four times the interval specified by the ip ospf hello-interval
command.
Example
Console(config)#interface vlan 1
Console(config-if)#ip ospf dead-interval 50
Console(config-if)#
Related Commands
ip ospf hello-interval (4-361)
4-360
I
NTERFACE

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SMC8748ML3 and is the answer not in the manual?

Table of Contents