Channel-Group; Lacp - SMC Networks SMC8748ML3 Management Manual

C L
OMMAND INE
• If a link goes down, LACP port priority is used to select the backup link.

channel-group

This command adds a port to a trunk. Use the no form to remove a port
from a trunk.
Syntax
channel-group channel-id
no channel-group
channel-id - Trunk index (Range: 1-32)
Default Setting
The current port will be added to this trunk.
Command Mode
Interface Configuration (Ethernet)
Command Usage
• When configuring static trunks, the switches must comply with the Cisco
EtherChannel standard.
• Use no channel-group to remove a port group from a trunk.
• Use no interfaces port-channel to remove a trunk from the switch.
Example
The following example creates trunk 1 and then adds port 11:
Console(config)#interface port-channel 1
Console(config-if)#exit
Console(config)#interface ethernet 1/11
Console(config-if)#channel-group 1
Console(config-if)#

lacp

This command enables 802.3ad Link Aggregation Control Protocol (LACP)
for the current interface. Use the no form to disable it.
Syntax
[no] lacp
4-206
I
NTERFACE