Enabling Lacp On Selected Ports - SMC Networks SMC8748ML3 Management Manual

C
ONFIGURING THE
CLI – This example creates trunk 1 with ports 9 and 10. Just connect
these ports to two static trunk ports on another switch to form a trunk.
Console(config)#interface port-channel 1
Console(config-if)#exit
Console(config)#interface ethernet 1/9
Console(config-if)#channel-group 1
Console(config-if)#exit
Console(config)#interface ethernet 1/10
Console(config-if)#channel-group 1
Console(config-if)#end
Console#show interfaces status port-channel 1
Information of Trunk 1
Basic information:
Port type:
Mac address:
Configuration:
Name:
Port admin:
Speed-duplex:
Capabilities:
1000full
Flow control:
Port security:
Max MAC count:
Current status:
Created by:
Link status:
Port operation status:
Operation speed-duplex: 1000full
Flow control type:
Member Ports: Eth1/9, Eth1/10,
Console#

Enabling LACP on Selected Ports

Command Usage
• To avoid creating a loop in the network,
be sure you enable LACP before
connecting the ports, and also
disconnect the ports before disabling
LACP.
• If the target switch has also enabled
LACP on the connected ports, the trunk
will be activated automatically.
3-128
S
WITCH
1000T
00-30-F1-D4-73-A2
Up
Auto
10half, 10full, 100half, 100full,
Disabled
Disabled
0
User
Up
Up
None
dynamically
enabled
active
links
configured
members
4-187
4-187
4-206
4-196
backup
link