Specifying Network Interfaces For Rip - SMC Networks SMC8748ML3 Management Manual

CLI - This example sets the router to use RIP Version 2, and sets the basic
timer to 15 seconds.
Console(config)#router rip
Console(config-router)#version 2
Console(config-router)#timers basic 15
Console(config-router)#end
Console#show rip globals
RIP Process: Enabled
Update Time in Seconds: 15
Number of Route Change: 0
Number of Queries: 1
Console#

Specifying Network Interfaces for RIP

You must specify network interfaces that will be included in the RIP
routing process.
Command Usage
• RIP only sends updates to interfaces specified by this command.
• Subnet addresses are interpreted as class A, B or C, based on the first
field in the specified address. In other words, if a subnet address
nnn.xxx.xxx.xxx is entered, the first field (nnn) determines the class:
- 0 - 127 is class A, and only the first field in the network address is used.
- 128 - 191 is class B, and the first two fields in the network address are
used.
- 192 - 223 is class C, and the first three fields in the network address
are used.
IP R
OUTING
4-325
4-328
4-325
4-335
3-295