Configuring Rate Limits - SMC Networks SMC8748ML3 Management Manual

C
ONFIGURING THE

Configuring Rate Limits

This function allows the network manager to control the maximum rate
for traffic transmitted or received on an interface. Rate limiting is
configured on interfaces at the edge of a network to limit traffic into or out
of the switch. Traffic that falls within the rate limit is transmitted, while
packets that exceed the acceptable amount of traffic are dropped.
Rate limiting can be applied to individual ports or trunks. When an
interface is configured with this feature, the traffic rate will be monitored
by the hardware to verify conformity. Non-conforming traffic is dropped,
conforming traffic is forwarded without any changes.
Command Attribute
Rate Limit – Sets the output rate limit for an interface.
- Default Status – Disabled
- Default Rate – Gigabit Ethernet: 1000 Mbps;
10 Gigabit Ethernet: 10000 Mbps
- Range – Gigabit Ethernet: 1 - 1000 Mbps;
10 Gigabit Ethernet: 1 - 10000 Mbps
3-144
S
WITCH