Ip Acls; Table 4-34 Ip Acl Commands - SMC Networks SMC8748ML3 Management Manual

C L
OMMAND INE
be bound exclusively to one of the basic ACL types (i.e., Ingress IP ACL,
Egress IP ACL, Ingress MAC ACL or Egress MAC ACL), but a mask can be
bound to up to four ACLs of the same type.
Command Groups Function

IP ACLs

MAC ACLs
ACL Information
IP ACLs
Command
access-list ip
permit, deny
permit, deny
show ip access-list
access-list ip
mask-precedence
mask
show access-list ip
mask-precedence
ip access-group
show ip access-group Shows port assignments for IP ACLs
4-116
I
NTERFACE
Table 4-33 Access Control List Commands
Configures ACLs based on IP addresses, TCP/UDP
port number, protocol type, and TCP control code
Configures ACLs based on hardware addresses, packet
format, and Ethernet type
Displays ACLs and associated rules; shows ACLs
assigned to each port

Table 4-34 IP ACL Commands

Function
Creates an IP ACL and enters
configuration mode for standard or
extended IP ACLs
Filters packets matching a specified
source IP address
Filters packets meeting the specified
criteria, including source and destination
IP address, TCP/UDP port number,
protocol type, and TCP control code
Displays the rules for configured IP
ACLs
Changes to the IP Mask mode used to
configure access control masks
Sets a precedence mask for the ACL rules IP-Mask
Shows the ingress or egress rule masks
for IP ACLs
Adds a port to an IP ACL
Page
4-116
4-128
4-137
Mode Page
GC 4-117
STD-ACL 4-118
EXT-ACL 4-119
PE 4-121
GC 4-122
4-123
PE 4-126
IC 4-127
PE 4-127