Flash/File Commands; Table 4-25 Flash/File Commands - SMC Networks SMC8748ML3 Management Manual

Command Usage
• This switch provides more efficient throughput for large sequential data
transfers by supporting jumbo frames up to 9216 bytes. Compared to
standard Ethernet frames that run only up to 1.5 KB, using jumbo
frames significantly reduces the per-packet overhead required to process
protocol encapsulation fields.
• To use jumbo frames, both the source and destination end nodes (such
as a computer or server) must support this feature. Also, when the
connection is operating at full duplex, all switches in the network
between the two end nodes must be able to accept the extended frame
size. And for half-duplex connections, all devices in the collision domain
would need to support jumbo frames.
• The current setting for jumbo frames can be displayed with the show
system command (page 4-80).
Example
Console(config)#jumbo frame
Console(config)#

Flash/File Commands

These commands are used to manage the system code or configuration files.
Command
copy
delete
dir
whichboot
boot system Specifies the file or image used to start up the system GC

Table 4-25 Flash/File Commands

Function
Copies a code image or a switch configuration to or
from flash memory or a TFTP server
Deletes a file or code image
Displays a list of files in flash memory
Displays the files booted
F /F C
LASH ILE OMMANDS
Mode
PE
PE
PE
PE
Page
4-84
4-87
4-88
4-89
4-90
4-83