Omron CX-PROCESS MONITOR PLUS V2 - 01-2007 Operation Manual page 206

Screen Configuration
Note
Setting Auto-saving of
CSV Files
6. Select the tag number for the batch trend collection. Register the tag name
and then set Detail as described below.
• Click the box to display the dialog box
shown below.
• Select the tag ITEM for the analog
ITEM that is to be registered. In this
example, a function block tag ITEM
(PV) with the tag name "Tag001" is
selected.
7. Select the option to enable auto-saving of CSV files (described below).
8. Click the OK Button.
The Batch Trend Screen will be registered and the screen name that was
input will be displayed on the Screen Management Tree.
If a setting is changed while the Continue previous batch when restarted
option is selected, the following dialog box will be displayed.
To make the change, click the OK Button. To cancel the change, click the Can-
cel Button.
The CSV file auto-save function is described below.
Enabling Auto-saving
When Auto-save enable is selected, a CSV file is automatically created when
the condition for the batch collection is stopped.
Destination Folder for Saved Files
Specify the destination folder for saved files at Destination folder to save.
The folder can be found by using the Browse Button. Within the destination
folder, folders will be automatically created for the dates on which the batch
collections are started, and the CSV files will be saved in those folders.
• Click the box to display the dialog box shown below.
• These settings are normally made automatically. It is
possible, however, that certain data (such as a PID
constant) may not match the display on the chart. In
cases such as that, the upper and lower limit settings
must be changed.
Section 5-5
191