Connecting Through A Controller Link Support Board; Connections Via Ethernet - Omron CX-PROCESS MONITOR PLUS V2 - 01-2007 Operation Manual

Connecting the PLC
2-2-2

Connecting through a Controller Link Support Board

Note
Controller Link Unit
Models
Controller Link Support
Boards
2-2-3

Connections via Ethernet

Note
The personal computer uses the FinsGateway Controller Link Driver to con-
nect to the PLC over a Controller Link Network.
CX-Process
Loop Control Unit
Monitor Plus
(IBM PC/AT or
Controller
compatible)
Link Unit
Controller Link Support Board
The FinsGateway CLK (PCI) Driver or Controller Link Driver with FinsGateway
version 2 or higher must be installed to enable connecting the PLC via a Con-
troller Link Network.
Controller Link Unit PLC
CS1W-CLK21-V1 CS1
CS1W-CLK12-V1
CS1W-CLK52-V1
CJ1W-CLK21-V1 CJ
Controller Link Transmission
Support Board
3G8F7-CLK12-V1 Optical fiber cable
(ring configuration)
3G8F7-CLK52-V1
3G8F7-CLK21-V1 Wire
3G8F5-CLK11-V1 Optical fiber cable
3G8F5-CLK21-V1 Wire
The personal computer uses the FinsGateway ETN_UNIT Driver to connects
to the PLC via Ethernet.
CX-Process
Monitor Plus
Loop Control Unit
IBM PC/AT or
compatible
Ethernet Unit
Ethernet
Ethernet Board
The FinsGateway ETN_UNIT Driver must be installed to enable connecting
the PLC via Ethernet.
Loop Control Unit
Controller
Link Unit
Controller Link Network
Unit Type
CPU Bus Unit Wired
Optical Ring Optical fiber cable
Optical
CPU Bus Unit Wired
Computer
medium
IBM PC/AT or com-
patible (PCI slot)
IBM PC/AT or com-
patible
Loop Control Unit
Ethernet Unit
Section 2-2
Transmission path
Twisted-pair cable
GI Optical fiber cable
Twisted-pair cable
FinsGateway
Driver
CLK (PCI slot)
Driver
(FinsGateway Ver-
sion 2 cannot be
used.)
Controller Link
Driver
49