Table of Contents
Advertisement
see the relevant memory technical paper in:
https://www.hpe.com/docs/server-memory
https://www.hpe.com/docs/server-memory
DIMM installation guidelines
DIMM installation guidelines
When handling a DIMM, observe the following:
Observe antistatic precautions.
Handle the DIMM only along the edges.
Do not touch the components on the sides of the DIMM.
Do not touch the connectors on the bottom of the DIMM.
Never wrap your fingers around a DIMM.
Never bend or flex the DIMM.
When installing a DIMM, observe the following:
To align and seat the DIMM, use two fingers to hold the DIMM along the side edges.
To seat the DIMM, use two fingers to apply gentle pressure along the top of the DIMM.
For more information, see the Hewlett Packard Enterprise website (https://www.hpe.com/support/DIMM-20070214-CN
Installing a DIMM
Installing a DIMM
Prerequisites
Prerequisites
Before you perform this procedure, review the:
DIMM population information
DIMM installation guidelines
About this task
About this task
CAUTION:
CAUTION:
Do not install ×4 and ×8 DRAM widths in the same server. All memory installed in the server must be of the same type.
Installing different DIMM types can cause the server to halt during BIOS initialization.
CAUTION:
CAUTION: A discharge of static electricity from a finger or other conductor might damage system boards or other static-
sensitive devices. To prevent damage, observe antistatic precautions.
Procedure
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Remove the server from the rack.
5. Place the server on a flat, level work surface.
https://www.hpe.com/support/DIMM-20070214-CN).
HPE ProLiant DL325 Gen11 Server User Guide
121
Advertisement
Table of Contents
