Rack Mounting Options - HPE ProLiant DL325 Gen11 User Manual

Install any hardware options before initializing the server.
If multiple options are being installed, read the installation instructions for all the hardware options to identify similar steps and
streamline the installation process.
If the hardware option installation involves internal cabling, review the Cabling guidelines.

Rack mounting options

Rack mounting options
Use the quick-deploy, toolless HPE rack rail option to install the server in a standard four-post rack. The rail design supports installation on
rack of different mounting interfaces.
For cable management, the rack rail kit might include one or both of the following options:
Rack rail hoop-and-loop strap
Cable management arm
Subtopics Subtopics
Rail identification markers Rail identification markers
Rack mounting interfaces Rack mounting interfaces
Rack rail options Rack rail options
Installing the server into the rack Installing the server into the rack
Installing the rack rail hook-and-loop strap Installing the rack rail hook-and-loop strap
Installing the cable management arm Installing the cable management arm
Rail identification markers Rail identification markers
The rack rail option support is dependent on these two factors:
The height and weight of the chassis as determined by the front- and rear-end server configurations.
The depth of the chassis as measured from the edge of the front panel (without the front bezel) to the edge of the rear panel.
To ensure compatibility between the rack rails and the server, verify that the rail number labels on the chassis match the ones stamped on
the rails.
Rail number labels on the chassis
HPE ProLiant DL325 Gen11 Server User Guide 67