HPE ProLiant DL325 Gen11 User Manual page 115

14. Connect following cables to the system board:
Optical drive cable
Front USB and DisplayPort cable
15. Install the middle cover .
16. Install the access panel .
17. Install the server into the rack.
18. Connect all peripheral cables to the server.
19. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
20. Power up the server.
21. Install the front bezel .
Results Results
The installation is complete.
Installing the front USB and DisplayPort option Installing the front USB and DisplayPort option
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
About this task About this task
In the SFF drive chassis, the front USB and DisplayPort option is included in the optical drive cage assembly kit. For more information, see
optical drive cage assembly installation in the SFF drive chassis .
HPE ProLiant DL325 Gen11 Server User Guide 115