Internal Usb Device Option; Installing An Internal Usb Device - HPE ProLiant DL180 Gen10 User Manual

Internal USB device option

The server has one internal USB 3.0 port. You can use this port to install internal USB device, that is intended to be rarely
removed, such as USB flash media devices for booting up from flash solutions or for data backup/redundancy.

Installing an internal USB device

Procedure
1. If installed, remove the front bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack.
6. Remove the access panel.
7. Locate the internal USB connector.
8.
Plug in the USB device into the internal USB port.
9. Install the access panel.
10. Install the server into the rack.
11. Connect all peripheral cables to the server.
12. Connect each power cord to the server.
13. Connect each power cord to the power source.
Hardware options installation
95