HPE ProLiant DL325 Gen11 User Manual page 139

15. Power up the server.
Results Results
The installation is complete.
Expansion card options Expansion card options
The server supports the installation of full-height half-length, full-height full-length, and half-height half-length (low-profile) PCIe expansion
/ add-in (AIC) cards such as:
HPE type-p storage controller
Ethernet adapter
HDR InfiniBand adapter
Fibre channel host bus adapter (FC HBA)
Accelerator (workload, computational, or graphics accelerator)
For more information on the expansion options validated for this server, see the server QuickSpecs on the Hewlett Packard Enterprise
website:
https://buy.hpe.com/us/en/p/1014689141 https://buy.hpe.com/us/en/p/1014689141
Subtopics Subtopics
Installing the full-length expansion card retainer Installing the full-length expansion card retainer
Installing an expansion card in the primary riser cage Installing an expansion card in the primary riser cage
Installing an expansion card in the NS204i-u + secondary low-profile riser cage Installing an expansion card in the NS204i-u + secondary low-profile riser cage
Installing the full-length expansion card retainer Installing the full-length expansion card retainer
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
About this task About this task
This card retainer is required when installing a full-length expansion card in the primary riser cage.
CAUTION: CAUTION: A discharge of static electricity from a finger or other conductor might damage system boards or other static-
sensitive devices. To prevent damage, observe antistatic precautions.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Remove the server from the rack.
5. Place the server on a flat, level work surface.
HPE ProLiant DL325 Gen11 Server User Guide 139