HPE ProLiant DL325 Gen11 User Manual page 164

The riser cage is aligned with the rear chassis.
The riser board is firmly seated on the system board.
b. Simultaneously push and rotate the half-turn spring latch to 180° (callout 2).
c. Close the spring latch (callout 3).
11. Install the access panel .
12. Install the server into the rack.
13. Connect all peripheral cables to the server.
14. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
15. Power up the server.
Results Results
The installation is complete.
M.2 SSD pass-through card option M.2 SSD pass-through card option
Install the dual-slot M.2 SSD pass-through card to support SATA or NVMe SSDs in 2280 or 22110 form factors .
Mixed SSD type installation is not supported.
Software RAID for NVMe SSDs is not supported.
Subtopics Subtopics
M.2 SSD pass-through card components M.2 SSD pass-through card components
Installing the M.2 SSD pass-through card Installing the M.2 SSD pass-through card
HPE ProLiant DL325 Gen11 Server User Guide 164