HPE ProLiant DL325 Gen11 User Manual page 53

4. Remove the server from the rack.
5. Place the server on a flat, level work surface.
6. Remove the access panel:
a. If necessary, unlock the access panel latch.
b. To disengage the access panel from the chassis, press the release button and pull up the latch.
c. Lift the access panel.
Remove the middle cover Remove the middle cover
Prerequisites Prerequisites
T-10 Torx screwdriver—this tool is for removing the middle cover from a server with the accelerator-optimized configuration.
About this task About this task
CAUTION: For proper cooling, do not operate the server without the access panel, baffles, expansion slot covers, or blanks CAUTION:
installed.
CAUTION: CAUTION:
To prevent damage to electrical components, properly ground the server before beginning any installation, removal, or
replacement procedure. Improper grounding can cause electrostatic discharge.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
HPE ProLiant DL325 Gen11 Server User Guide 53