HPE ProLiant DL325 Gen11 User Manual page 131

12. Cable the type-p storage controller .
13. To enable the FBWC feature of the storage controller, install an energy pack.
14. If removed, install the middle cover .
15. Install the access panel .
16. Install the server into the rack.
17. Connect all peripheral cables to the server.
18. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
19. Power up the server.
20. Update the server firmware if they are not the latest revision .
21. Configure the controller .
Results Results
The installation is complete.
Installing a type-o storage controller (OROC) Installing a type-o storage controller (OROC)
Prerequisites Prerequisites
To enable the flash-backed write cache (FBWC) feature of a storage controller option, install an energy pack.
For more information on the controller caching feature, see the controller QuickSpecs on the Hewlett Packard Enterprise website
(https://www.hpe.com/info/qs https://www.hpe.com/info/qs).
Before you perform this procedure, make sure that you have the following items available:
Compatible controller cable
T-10 Torx screwdriver
Spudger or any small prying tool
About this task About this task
This server supports type-o storage controller installation in the OCP slot 22.
CAUTION: CAUTION:
The port blank provides EMI shielding and helps maintain proper thermal status inside the server. Do not operate the server
when a port blank is removed without the corresponding I/O port option installed.
CAUTION: CAUTION: A discharge of static electricity from a finger or other conductor might damage system boards or other static-
sensitive devices. To prevent damage, observe antistatic precautions.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
HPE ProLiant DL325 Gen11 Server User Guide 131