HPE ProLiant DL325 Gen11 User Manual page 60

3. Install the access panel .
4. Perform the post-installation or maintenance steps required by the procedure that necessitates the removal of the air baffle.
Install the middle cover Install the middle cover
Prerequisites Prerequisites
T-10 Torx screwdriver—this tool is for installing the middle cover on a server with the accelerator-optimized configuration.
About this task About this task
CAUTION: For proper cooling, do not operate the server without the access panel, baffles, expansion slot covers, or blanks CAUTION:
installed.
CAUTION: CAUTION:
To prevent damage to electrical components, properly ground the server before beginning any installation, removal, or
replacement procedure. Improper grounding can cause electrostatic discharge.
Procedure Procedure
1. To install the middle cover on the LFF and SFF drive configuration, take both sides of the middle cover and install on the server.
LFF drive configuration
HPE ProLiant DL325 Gen11 Server User Guide 60