Internal Usb Device Option - HPE ProLiant ML110 Gen10 User Manual

12. Make sure that the board is firmly seated on the slot.
13. Close the PCIe slot cover retainer.
14. Connect the M.2 SATA SSD cables.
15. Install the system air baffle.
16. Install the PCI air baffle.
17. Install the access panel.
18. Do one of the following:
Server in rack mode: Install the server into the rack.
•
• Server in tower mode: Return the server to an upright position.
19. Connect all peripheral cables to the server.
20. Connect each power cord to the server.
21. Connect each power cord to the power source.
22. Power up the server.
The installation is complete.
To configure the M.2 SATA SSDs, see the HPE Smart Array SR Gen10 Configuration Guide at the Hewlett Packard
Enterprise website.

Internal USB device option

The server provides one internal USB 2.0 port and one USB 3.0 port. You can use these two ports to install internal USB
devices such as USB flash media devices. These devices are rarely removed and are used for booting up from flash
solutions or for data backup/redundancy.
Hardware options installation
102