Table of Contents
Advertisement
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack.
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Remove the NS204i-u + secondary low-profile riser cage:
a. Release the half-turn spring latch.
b. Lift the riser cage off the system board.
9. Install the security cover for the boot device.
10. Install the NS204i-u + secondary low-profile riser cage:
a. Carefully press the riser down on its system board connector (callout 1).
Make sure that:
HPE ProLiant DL325 Gen11 Server User Guide
163
Advertisement
Table of Contents
