Table of Contents
Advertisement
Remove the server
Remove the
server from the
from the rack
Prerequisites
Prerequisites
Get help to lift and stabilize the server during removal from the rack. If the
person might be required to help remove the server
person might be required to help remove the
the rack.
Before you perform this procedure, review the:
Rack warnings and cautions
Server warnings and cautions
A fully populated server is heavy. Hewlett Packard Enterprise recommends removing the external server components before removing
the server from the rack.
T-25 Torx screwdriver—This tool is required if the shipping screws located inside the chassis ears are secured.
Procedure
Procedure
1. Power down the server.
2. Press and hold the blue PUSH
PUSH button on the retention bracket.
3. Swing the arm away from the rear panel.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. If needed, loosen the shipping screws, and then use the chassis ear latches to slide the server out of the rack until the front-end rail-
release latches are engaged.
rack
server: : One person to support the server weight, and the other to slide the server out of
If the server
server is installed higher than chest level, an additional
is installed higher than chest level, an additional
HPE ProLiant DL325 Gen11 Server User Guide
50
Advertisement
Table of Contents
