Table of Contents
Advertisement
Mezzanine card option
The server supports a mezzanine card to install an internal USB device that can be used as a flash boot media or for data
backup/redundancy.
Installing the mezzanine card for internal USB device
Procedure
1.
Power down the server.
2.
If installed, disconnect the tube set.
3.
Disconnect all peripheral cables from the server.
4.
Remove the server.
5.
Place the server on a flat, level work surface.
6.
Remove the node cover.
7.
Plug in the USB device into the USB port of the mezzanine card.
8.
Install the mezzanine card:
a. Insert the spacers on the system board through the holes on the card (callout 1).
b. Carefully press the card down on its system board connector (callout 2).
Make sure that the card is firmly seated.
c. Tighten the card thumbscrew (callout 3)
Hardware options installation
82
Advertisement
Table of Contents
