Table of Contents
Advertisement
15. Connect the M.2 SSD pass-through signal and power cables .
16. If an energy pack was removed from the left chassis wall, do the following:
a. Secure the energy pack in the retention latch located on the rear side of the drive cage.
b. Connect the energy pack extension power cable to the system board and energy pack cable .
c. Install the middle cover .
17. Install the access panel .
18. Install the server into the rack.
19. Connect all peripheral cables to the server.
20. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
21. Power up the server.
HPE ProLiant DL325 Gen11 Server User Guide
170
Advertisement
Table of Contents
