Table of Contents
Advertisement
12. Make sure that the board is firmly seated on the slot.
13. Close the PCIe slot cover retainer.
14. Connect the M.2 SATA SSD cables.
15. Install the system air baffle on page 31.
16. Install the PCI air baffle on page 30.
17. Install the access panel on page 26.
18. Do one of the following:
•
Server in rack mode: Install the server into the rack on page 53.
•
Server in tower mode: Return the server to an upright position.
19. Connect all peripheral cables to the server.
20. Connect each power cord to the server.
21. Connect each power cord to the power source.
22. Power up the server on page 23.
The installation is complete.
To configure the M.2 SATA SSDs, see the HPE Smart Array SR Gen10 Configuration Guide at the Hewlett
Packard Enterprise website.
Internal USB device option
The server has one internal USB 2.0 port and one USB 3.0 port. You can use these two ports to install
internal USB devices, that are intended to be rarely removed, such as USB flash media devices for booting up
from flash solutions or for data backup/redundancy.
Hardware options installation
89
Advertisement
Table of Contents
