HPE ProLiant DL325 Gen11 User Manual page 32

The arrow points to the front of the server.
Fan and heatsink requirements Fan and heatsink requirements
CAUTION: CAUTION: To maintain proper system cooling, install the correct fan and heatsink types required for specific hardware
configurations.
CAUTION: CAUTION: To maintain proper system cooling, when a 25 Gb or faster Ethernet / InfiniBand adapter / HPE Storage
Networking NVMe-oF Offload Adapter / HPE NS204i-u Boot Device / accelerator is installed in any configuration, make
sure to use high performance fans.
The system-operating temperature for most components installed in this server is at standard temperature ( 10°C to 35°C / 50°F to 95°F ).
However, system performance during standard operating support may be reduced if operating above 30°C (86°F). The following table
contains the allowed hardware configurations that the system can be run at 30°C (86°F) without system performance degradation.
4 LFF drive configurations 4 LFF drive configurations
Processor TDP Processor TDP
1
≤ 240 W
≤ 240 W
≤ 300 W
≤ 400 W
The maximum recommended ambient operating temperature is 27℃.
1
Option kit: P58461-B21
2
Option kit: P58456-B21
3
Option kit: P58457-B21
4
Option kit: P58462-B21
5
Option kit: P59668-B21
6
Option kit: P58463-B21
7
8 SFF drive configurations 8 SFF drive configurations
Fan type Fan type Heatsink type
2
Standard fan
5
High performance fan
6
Liquid cooling fan
Heatsink type
3
Standard heatsink
4
High performance heatsink
4
High performance heatsink
7
Liquid cooling heatsink
HPE ProLiant DL325 Gen11 Server User Guide 32