HPE ProLiant DL320 Gen11 Maintenance And Service Manual page 110

IMPORTANT: IMPORTANT: The fan setup can either be all 7 of standard or high performance fans. Do not mix fan types in the same
server.
Procedure Procedure
1. Power down the server.
2. If installed, open the cable management arm .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Remove the M.2 air baffle .
9. Remove the fan.
Results Results
To replace the component, reverse the removal procedure.
Removing and replacing the fan board Removing and replacing the fan board
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
About this task About this task
Procedure Procedure
1. Power down the server.
2. If installed, open the cable management arm .
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide 110