Removing And Replacing The Serial Port Blank - HPE ProLiant DL320 Gen11 Maintenance And Service Manual

2. If installed, open the cable management arm .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Remove the riser cage.
9. Disconnect the serial port cable from the system board .
10. Remove the serial port:
a. Remove the hex screws (callout 1).
b. Detach the serial port from the rear panel (callout 2).
Results Results
To replace the component, reverse the removal procedure.

Removing and replacing the serial port blank

Removing and replacing the serial port blank
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a spudger or any small prying tool available.
About this task About this task
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide 112