HPE ProLiant DL320 Gen11 Maintenance And Service Manual page 113

CAUTION: CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated with
either a component or a blank.
Procedure Procedure
1. Remove the serial port blank:
a. Detach the right side of the blank (callout 1).
b. Repeat step a on the left side to remove the blank (callout 2).
2. Immediately install the new serial port blank.
Optical drive replacement Optical drive replacement
Subtopics Subtopics
Removing and replacing the optical drive cage Removing and replacing the optical drive cage
Removing and replacing an optical drive from the LFF drive chassis Removing and replacing an optical drive from the LFF drive chassis
Removing and replacing the optical drive from the optical drive cage Removing and replacing the optical drive from the optical drive cage
Removing and replacing an optical drive blank Removing and replacing an optical drive blank
Removing and replacing the optical drive cage Removing and replacing the optical drive cage
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
T-15 Torx screwdriver
Phillips No. 1 screwdriver
About this task About this task
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide 113