HPE ProLiant DL320 Gen11 Maintenance And Service Manual page 49

Remove the middle cover Remove the middle cover
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
This tool is required to remove the middle cover from the GPU dense configuration.
About this task About this task
CAUTION: CAUTION: For proper cooling, do not operate the server without the access panel, baffles, expansion slot covers, or blanks
installed.
CAUTION: CAUTION:
To prevent damage to electrical components, properly ground the server before beginning any installation, removal, or
replacement procedure. Improper grounding can cause electrostatic discharge.
Procedure Procedure
1. Power down the server.
2. If installed, open the cable management arm .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. To remove the middle cover from the LFF and the SFF drive configuration, take both sides of the middle cover and detach from the
server.
LFF drive configuration
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide 49