Table of Contents
Advertisement
To replace the component, reverse the removal procedure.
Removing and replacing the internal LFF drive cage backplane
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
CAUTION: To prevent damage to electrical components, take the appropriate anti-static precautions before
beginning any installation, removal, or replacement procedure. Improper grounding can cause electrostatic
discharge.
Prerequisites
Before you perform this procedure, make sure that you have the components included with the hardware kit.
Procedure
1. Power down the system (Power down the system).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the system.
3. Remove the system from the rack (Remove the system from the rack).
4. Place the system on a flat, level surface.
5. Pull down the front drive cage release latches and use them to completely extend the front drive cages from the
chassis (Extend the front drive cages out of the chassis).
6. Remove the air blocker.
80
Removal and replacement procedures
Advertisement
Table of Contents
