9. If the storage controller backup cable is connected, disconnect the cable .
10. To remove the rear riser cage, do the following:
a. Release the half-turn spring latch (callouts 1 and 2).
b. Lift the riser cage off the system board (callout 3).
11. To remove the front GPU riser cage, do the following:
a. Remove the two screws (callout 1).
Retain the screws for future use.
b. Push the riser cage forward and slide it out (callout 2).
Remove the fan
Remove the fan
About this task
About this task
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide
54