Removing And Replacing A Dimm Guard - HPE ProLiant DL320 Gen11 Maintenance And Service Manual

2. If installed, open the cable management arm .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
6. Remove the access panel .
7. Remove the DIMM.
a. Open the DIMM slot latches (callout 1).
b. Lift the DIMM out of the slot (callout 2).
Results Results
To replace the component, reverse the removal procedure.

Removing and replacing a DIMM guard

Removing and replacing a DIMM guard
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
About this task About this task
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide 86