Installing The System Board Assembly - HPE ProLiant DL320 Gen11 Maintenance And Service Manual

Installing the system board assembly

Installing the system board assembly
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
T-15 Torx screwdriver
T-30 Torx screwdriver
Hex screwdriver—This tool is required if the serial port cable is to be installed.
Thermal grease
About this task About this task
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
Procedure Procedure
1. Install the new system board assembly:
a. Slide the system board into the base pan (callout 1).
b. Tighten the thumbscrew (callout 2).
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide 173