HPE ProLiant DL320 Gen11 Maintenance And Service Manual page 89

Results Results
To replace the component, reverse the removal procedure.
Removing and replacing the M.2 air baffle Removing and replacing the M.2 air baffle
About this task About this task
Procedure Procedure
1. Power down the server.
2. If installed, open the cable management arm .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Remove the M.2 air baffle.
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide 89